EQ-3 MAX! Cube Manual do Utilizador descarregar pdf (Página 21)

Browser: Internet Explorer® Version 7.0 or higher,

Mozilla Firefox® Version 3.6.16 or

higher, Safari Version 5 or higher,

Google Chrome Version 8 or higher

6.3 Installing the devices

In order to enable communication between MAX! com-

ponents, the devices have to be taught in to one another.

The devices should be installed room by room and, within

rooms, one device at a time. To do this, proceed as follows:

If you have already used the single room solution

with a MAX! Wall Thermostat, please restore the

factory settings of all devices before teaching in to

the MAX! cube. For further details, please see the

corresponding operating manual.

• Install the device that you want to teach in on the MAX!

system (e.g. MAX! radiator thermostat) by following the

instructions in the relevant operating manual.

• Select „New device“ in the software to switch the MAX!

cube to teach-in mode.

• Set the device that you want to teach in on the MAX! sys-

tem (e.g. MAX! radiator thermostat) to teach-in mode by

following the instructions in the relevant operating manual.

• The device appears in the software.

• In the software, click „Next“.

• Assign a name for the device. Allocate the device to

a room.

• Follow the same procedure for all the other devices that

you want to teach in on the MAX! system.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Sem comentários

EQ-3 MAX! Cube Manual do Utilizador Página 21